TO LOAD CONTINUOUS VOUCHERS FROM THE REAR.  (TO PRINT VOUCHERS)

1. Make sure Printer is Turned On.  (The print head may travel back and forth, if it does, wait until it stops to continue.)
2. Move the paper lever forward to Rear Feed Position, labeled REAR.
3. Lift the front edge of the rear cover and pivot it up to access the tractors.
4. Pull up on the lock levers to release the tractors and swing open the tractor covers.  (Push the left hand tractor all the way to the right until it stops then lock into position).
5. Place the first two holes on the continuous voucher on each side over the tractor pins.

NOTE:  An equal number of paper holes must be engaged on either trator in order to ensure that the paper will feed properly.

6. When the paper is properly aligned lock the right tractor into position.

SPECIAL NOTE:  Be sure the holes on the paper are centered on the pins, (if the paper is stretched too tight or too loose it can jam and cause problems).

7. To load the continuous vouchers, push the FF/LOAD button.  Paper will automatically feed into the printer and the alarm light will go out.  (Be sure that the SEL light is on.  If not press SEL to turn it on).
8. The printer and vouchers are ready to print.
9. After the receipt is printed it will move to the top of the tear bar, simply tear it off and continue with your next member.